While Samuel was struggling with adb again, he discovered that you need to DETACH the USB cable first before you connect adb using the ip address. We added the linear slide code to the current competition robot, so now
11/12/16 Hardware
Throughout the week, plates were attached to the autonomous beacon attachment to increase the likelihood of pressing the beacon. The servos for the claw mechanism were originally the 180 degree ones, but these didn’t have enough range for the claws
Technicbots Meeting #10 – 11/12/16
Italics means action items not done last week. Strike through means items that will not be checked this week, but will be checked in the future. Take team member attendance in the team attendance tracker sheet in blog (Jerry) Check availability
11/5/16 Hardware
Harvester: Finished prototype with duct tape attached to one set of wheels. Final attachment to build this week: -Keep base design -Replace wheels with gears and tapes with treads Shooter: After 200 or so shots the poly carbonate piece
11/5/16 CAD
Windchill Update Situation- As of now, I can only say that Windchill Update is just not very stable. As I have been searching across the PTC forum, and most people say that Windchill Update does not work correctly. New system
11/5/16 Software
We programmed the other side of the autonomous navigation today. Brandon didn’t put in some essential instructions on connecting the adb, so Samuel put it in in the previous engineering notebook entry that contained that post. The blue side of
Technicbots Meeting #9 – 11/5/16
Italics means action items not done last week. Strike through means items that will not be checked this week, but will be checked in the future. Take team member attendance in the team attendance tracker sheet in blog (Jerry) Check availability
10/29/16 Software
On the competition robot, we programmed the autonomous to start against the wall and drive back and push the first beacon. The robot starts between the two beacons and drive backwards using the wheels on the side until the light
10/29/16 Hardware
Cap ball update: The robot will first go through with the claw design inside of the ring design, because it is easier to hook onto the cap ball and overall less complicated. There will be servos attached to gears
10/29/16 CAD
Yellow – Chassis White – Auto Beacon Blue – Intake Red- Shooter Green – Cap ball Brown – Tele Beacon This is our new system envelope from the 10/29 meeting. Current Cad Development- The