4/15/17 CAD
Technicbots Meeting #27 – 4/15/2017
Italics means action items not done last week. Strike through means items that will not be checked this week, but will be checked in the future. Check availability for the meeting (4/15): Amanda will not be there. Agenda (7:00pm): Action Items
4/8/17 CAD
Linear Slide and Cap Ball Mechanism Measurements are in mm. We used the REV 15 mm extrusions in our linear slide, and cut them to 14 inches long. Measurements are in inches. This piece holds the cap ball mechanism
4/8/17 Software
4/8/17 Hardware
Technicbots Meeting #26 – 4/8/17
Italics means action items not done last week. Strike through means items that will not be checked this week, but will be checked in the future. Check availability for the meeting (4/8): Jerry, Abhishek, Amanda, Evan will not be there
4/1/17 CAD
CAD Working on updating super regional robot. Still need some help to fix the beacon pressers. Blue Print for Shooter
4/1/17 Hardware
A rotating beacon hitter that stretches across the frame of the sweeper was added to more easily hit beacons in end game. Additionally, diagonals beams were added on both sides of the linear lift claw to prevent the claws from
4/1/17 Software
We tried to use the Adafruit IMU sensor for a replacement for our gyro, but could not get a reading. We will try again in the off season. We also made small changes to our autonomous to use the light